Minli New Materials (Guangzhou) Co., Ltd.

Tel:400-086-6586
No filling series Home > Porudcts

【 Brand 】Sitley

【 Model number 】 7036

Model number7036(No filler coated hot melt adhesive)

Product Nature:

The appearance is light yellow and transparent, with oval particles. Take ethylene and vinyl acetate as the main raw materials, add tackifying resin。

Technical Parameters:

20000±5000mpa.s when the viscosity value is 180℃

density1.01g/cm3

Softening Point80-90℃

Anti-hot spot>60℃

Operating parameters:

Material humidity>15℃

Ambient temperature>15℃

Material moisture content8%-10%

Glue tank temperature160-180℃

Rubber roller temperature160-200℃

pressure3-5kg/cm3

Feeding speed>15米/分钟

Scope of use:

Suitable for small and medium-sized wire wrapping machines: lamination between particle board, solid wood, MDF and decorative surface materials (decorative paper)

Suitable for material feeding speed of 20-50 m/min, strong bonding strength。

product features:

1.Suitable for most domestic coating machines;

2.High heat resistance, high strength, low temperature resistance, may be added with subsequent spray painting;

3.Good fluidity, thin and uniform coating:

4.It works well in the assembly process。

Use hot melt adhesive method and matters needing attention:

1. To understand and master the various models and technical performance (including technical parameters) of hot melt adhesives.

2. The temperature of the hot melt glue tank should be controlled within the operating temperature range.

3. Clean the preheated glue pot regularly to keep the glue pot clean.

4. Plates and edge banding materials should be protected from contamination.

5. The moisture content of wood should be around 8%-10%.

6. The amount of glue in the glue pot should be properly controlled. If the amount is too much, the glue will melt in turns, which will cause deterioration and aging, lower viscosity, and affect adhesion.


Tel

400-086-6586

Online Service